Services

CMM
  • Spline Gauge
  • Master Gear
  • Mandrel
  • Tapered Mandrel
  • Caliper Checker
  • Rig Bars
  • Flush Pin Gauge
  • Position Gauge
  • Depth Gauge
  • Rig Bars
  • Custom Gauges as per Drawing
  • Master Ring Gauge
  • Tapered Plug and Ring Gauge
  • Length Bar
  • Laser Tracker Master
  • Right Angle / Tri Square
  • V Block
  • Keyway Guide
  • Granite Square
  • Cone Master
  • Straight Edge
  • Templets
ULM
  • Thread Plug Gauge
  • Thread Ring Gauge
  • Setting Ring Gauge
  • Setting Plug Gauge
  • Pin Gauge
  • OD Master
  • Master Sphere
  • Bore Gauge
  • Setting Rod
  • Feeler Gauge
  • Custom Gauges as per Drawing
  • Snap/Gap Gauge
  • Width Gauge
  • Inside Micrometer
  • Length Bar
  • Foils
  • Thread Measuring Wires / Wire Gauge
DIAL GAUGE CALIBRATOR
  • Lever Dial Gauge
  • Plunger Dial Gauge
  • Millimess
  • Supramess
SLIP GAUGE CALIBRATOR
  • Slip Gauge –Grade 1 and 2
VISION MEASURING MACHINE
  • Radius Gauge
  • Pitch Gauge
  • Wet Film Thickness Gauge
  • Bevel Protractor
  • Glass Scale
  • Protractor
  • Weld Gauge
  • Flow Cup/Viscosity Cup (Diameter)
  • Seive
  • Test Seive
  • Tapered Scale
  • Combination Set
  • Angle Protractors
  • Templets
  • All kinds of Profile Gauges
ELECTRONIC COMPARATOR
  • Long Slip gauge
  • Artifact comparisons
ROUGHNESS TESTER MACHINE
  • Roughness Comparator
SCALE AND TAPE MEASURING MACHINE
  • Measuring Scale
  • Measuring Tape
  • Pie Tape
  • Steel Scale
GAUGE BLOCK – MASTER STEP GAUGE
  • Vernier Caliper (All Types)
  • Micrometer (All Types)
  • Depth Caliper
  • Height Gauge
  • Height Master
  • Dial Thickness Gauge
  • Electronic Probes with DRO
  • Proximity Sensor
  • High Low Gauge
  • LVDT Probe
COATING THICKNESS GAUGE & FOILS
  • Coating Thickness Measurement
  • Foils
  • DFT Gauge
GLASS SCALE & GLASS PROCTRACTOR
  • Profile Projector
  • Video Measuring Machine
  • Microscope
PRECISION ELECTRONIC LEVEL
  • Granite Surface Plate
  • Cast Iron Surface Plate
  • Sprit Level
  • Electronic Level (Comparison Method)
TAPERED AND STRIAGHT MANDERALS
  • Bench Center
GRANITE SURFACE PLATE & GRANITE SQUARE
  • Height Gauge Squareness
  • Straightness
  • Reconditioning of surface plates
MASTER TRIANGLE & LONG SLIP GAUGE
  • CMM Calibration
REPAIR OF INSTRUMENTS UNDERTAKEN BY THE LABORATORY